Progress PHN3325X Manuel d'utilisateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
Installing the door and the glass panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence. In-
stall the smaller panel first, then the larger.
WHAT TO DO IF…
Warning! Refer to the Safety chapters.
Problem Possible cause Remedy
The cooking zones do not op-
erate.
Refer to the operating instructions for the built-in cooking surface.
The appliance does not heat
up.
The appliance is deactivated. Activate the appliance.
The appliance does not heat
up.
The clock is not set. Set the clock. Refer to "Setting
and changing the time".
The appliance does not heat
up.
The necessary settings are not
set.
Make sure that the settings are
correct.
The appliance does not heat
up.
The automatic cut-out is activa-
ted
Refer to „Automatic switch-off“.
The appliance does not heat
up.
The fuse is released. Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display shows F102. The door lock is defective. Fully close the door.
Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows F102
again, contact the Customer
Care Department.
The display shows an error
code that is not in this list.
There is an electrical fault. Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity.
We recommend that you write the data here:
28 progress
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire